Pile Foundation Functions


When the soil beneath the level at which a footing or raft would normally be established is too weak or too compressible to provide adequate support, the loads are transferred to more suitable material at a greater depth by means of piles or piers. The distinction between the two is somewhat arbitrary.

Piles

Piles are the structural members of small cross-sectional area compared to their length, and are usually instated by a driver consisting of a hammer or a vibrator. They are often grouped into clusters or rows, each containing enough piles to support the load delivered by a single column or wall.

Pile Foundation Functions   Why Piles Are Used ase129

Important Factors To Consider During Pile Design

A lightly loaded column may, in some instances, require only a single pile. However, since under field conditions the actual position of a pile may be  as much as several inches from its planned location, an eccentric loading can hardly be avoided. Consequently, the heads of single piles are usually braced in two directions by grade beams. If only two piles are needed, their heads may be connected by a concrete cap braced by grade means in only one direction, perpendicular to the line joining the two piles Fig.1(b). Clusters containing three or more piles are provided with reinforced concrete caps, as shown in Fig.1(c), and are considered stable without support by grade beams.

Pile Foundation Functions   Why Piles Are Used page 204 955x1024

Vertical piles may also be used to resist lateral loads as for example, beneath a tall chimney subject to wind. Compared to their axial capacity, the lateral capacity is usually small. Where large lateral loads are to be used (Fig.1d.) Batters of 4 horizontal : 12 vertical represent about the greatest inclination that can be achieved with ordinary driving equipment. Economy usually favors smaller inclinations even if more piles have to be battered.

Functions of Pile Foundation

Piles are used if the bearing capacity of soil at shallow depth is not enough to withstand the structural load. So the piles are driven  to transfer the loads from the structure to the high bearing capacity soil/rock stratum. The main functions of using pile foundations are listed below in short.

  • To transfer the load from the structure to the foundation at a greater depth where the \bearing capacity of soil is efficient to withhold the structure loads.
  • Pile controls the soil settlement which can be accompanied by surface foundations.
  • Piles are used to increase the safety factor for high loaded structures.
  • Piles enable the scope of construction in very low bearing capacity soils

Note : Article Courtesy : http://civilengineersforum.com/function-of-pile-foundation/

Beirut Terraces by Herzog & de Meuron


Herzog & de Meuron Beirut Terraces

Swiss architects Herzog and de Meuron have designed this apartment tower with overhanging floor plates and terraces for Beirut, Lebanon.

Herzog & de Meuron Beirut Terraces

Created as part of a wider masterplan to regenerate this area of the city that includes a marina, the building will comprise five different modular floor slabs used in varying combinations to create a mixture of overhangs and terraces.

Herzog & de Meuron Beirut Terraces

The building will have vegetation on the terraces to provide privacy and in the main entrance space to act as continuation of the neighbouring green boulevard.

Herzog & de Meuron Beirut Terraces

The 116 metre-high structure will be supported by columns on a 14.7 metre regular grid, with each floor plate overhanging the glazing by at least 60 centimetres.

Beirut Terraces Herzog & de Meuron

129 single, duplex and townhouse apartments will be available, arranged in different clusters throughout the tower.

Herzog & de Meuron Beirut Terraces

The project is due for completion in 2013.

Herzog & de Meuron Beirut Terraces

NOTE:
Courtesy: http://www.dezeen.com/2010/07/27/beirut-terraces-by-herzog-de-meuron/